View previous topic :: View next topic |
Author |
Message |
SeoulnPepe
Joined: 13 Sep 2006 Location: Seoul
|
Posted: Wed Feb 27, 2008 1:52 am Post subject: DSLR Sensor Cleaning |
|
|
Hi,
Anyone out there done any sensor cleaning? How much work is it? Are cleaning supplies readily available in Seoul?
Do DSLRs with dust-cleaning/prevention built in need cleaning as well?
Look forward to reading your experiences. |
|
Back to top |
|
 |
tractor

Joined: 26 Jan 2008
|
Posted: Wed Feb 27, 2008 2:53 am Post subject: |
|
|
when i had a d70 4 years ago, i read on the internet that you could use an aerosol air spray. BIG MISTAKE! it blew the chemical contents on to the sensor. had to pay around $80 to get it cleaned. thank goodness the sensor was covered with the Infrared screen or i would have been really screwed. bad internet recommendation...
the people at nikon service repair shop told me to use a lens dust blower or get it professionally cleaned next time.
my D200 doesn't have a self dust-cleaning option, so not too sure how well it would work.
this looks good:
 |
|
Back to top |
|
 |
Demophobe

Joined: 17 May 2004
|
Posted: Wed Feb 27, 2008 3:15 am Post subject: |
|
|
Go in your bathroom and wet the place down. Close the door for 10 minutes, prep your camera for lens removal and get out the cleaning supplies. Wipe it yourself, take some white shots (the wall or take a white card in with you) to check that it's clean, then do it up. Use cold water when you wet down the bathroom and turn off the exhaust fan. Use new, dustless cloths each time and don't re-use them.
Worked for me for a long time. Every time I took it to the Canon center, it was no better than when I took it is. DIY is the way. |
|
Back to top |
|
 |
Atavistic
Joined: 22 May 2006 Location: How totally stupid that Korean doesn't show in this area.
|
Posted: Wed Feb 27, 2008 4:26 am Post subject: |
|
|
^^ Do what he said, but BEFORE wiping it, use a blower (NOT aerosol, as the other guy said, that can really mess things up! NOT compressed air! NOTHING harsh!) to try and remove as much dust as possible. Hold the camera DOWN while you do this so gravity works in your favor. Then try shooting the white paper. If it's still showing spots, then go to actually cleaning the sensor.
TREAD LIGHTLY. |
|
Back to top |
|
 |
|