Korean Job Discussion Forums

[Sincinnatislink]

I wanted to talk with everyone possible before hassling my boss.
My wall mounted water heater is acting up.
I've turned it off from the wall controlled, unplugged it and plugged it back in, and now I've left it alone and off during my workday to let it rest or whatever. No dice.

It is leaking water lightly, and the wall-mounted controller is giving me error messages. The light above the korean words "Confirm/Check" is flashing, the light next to the green button turns off, and the following numbers have flashed so far after the heater tries to heat up.
Last night, it was "10," this morning, it was "09" and now it's "03."

[blackjack]

make, model and/or photos might help

[sojourner1]

It's broken. You need repair service or a new one.

[Sincinnatislink]

[img]http://gmschroeder.files.wordpress.com/2008/01/ondol.jpg[/img]

The light that is second from the top on the left is the blinking one.

The numbers, again, are 10, 09, and sometimes 03.

It worked for a bit, and now it stopped again, giving me a "10" and then a "09."

If someone could tell me how the heck to get bbcode working here, I'd be much obliged.

[billybrobby]

I have the exact same one. Honestly, I've never figured it out either. In summer, I usually keep button 1 off and button 2 pressed down (button 2 is specifically for heating water) and that works, but then some days, completely randomly, I don't get any hot water and I have to press button 1 down. Hot water comes, and then I un-press it and don't have to press it again for weeks. Makes no sense to me.

Anyways, if the 확인 button is blinking, then you should 확인 that shit. Did you pay your gas bill? The only time mine gave me trouble is for not paying my bill. Also, that leak sounds like something you should definitely fix too. Just call you boss.

[billybrobby]

ps - nice wall paper